Won't Drain
Water left in the drum usually means a blocked pump or filter — quick to clear and test.
Loud spin, won't drain, door stuck or stopping mid-cycle? Our engineers handle the drum, motor and electronics and get your Smeg washer running clean again.
A washing machine that won't drain or stops mid-cycle brings the whole house to a halt. The good news: most Smeg washer faults are well-known and very repairable — leaks, drainage, bearings, door locks and control boards.
We diagnose on-site, carry the common parts, and give you a fixed price before starting. Most repairs are done in one visit, all backed by a 90-day warranty.
If your smeg washing machine is doing any of these, we've almost certainly seen it before — and fixed it.
Water left in the drum usually means a blocked pump or filter — quick to clear and test.
Banging or grinding on spin often points to worn bearings or a loose drum, caught early.
Leaks traced to the door seal, hoses or pump and sealed so your floor stays dry.
Stuck on a finished cycle? Door-lock and latch faults released and repaired.
Stopping part-way through is usually a sensor or control-board fault we can pin down.
Belt, motor and capacitor faults that leave your washing soaking wet, sorted out.
A clear, no-guesswork process from first call to final test.
Call or WhatsApp and tell us the appliance and what it's doing. We book a slot that suits you.
An engineer inspects it on-site and pins down the real fault before touching anything.
You get a clear, fixed price up front. Nothing happens until you say go.
We repair, test it with you, tidy up and leave you with a 90-day warranty.
General handymen guess. Our engineers diagnose. Because we focus on Smeg, the person who arrives at your door has repaired your exact smeg washing machine model many times before — which means a faster, more accurate fix and fewer repeat visits.
Every technician is trained on Smeg control boards, compressors and electronic modules.
We fit genuine-grade Smeg spares so repairs hold up long after we leave.
Same-day and emergency slots, seven days a week, with engineers who turn up on time.
Usually yes. A non-draining washer is normally a blocked pump or filter, which we clear and test the same visit in most cases.
Loud spinning often means worn drum bearings. It's best repaired before it gets worse and damages other parts, so it's worth booking sooner rather than later.
That's a common door-lock fault. We can release it safely and repair the latch so it doesn't happen again.
Most washing machine repairs are completed in a single visit. If a less common part is required, we'll let you know up front.
Yes, all three, with same-day appointments in most areas.
An engineer who knows Smeg is one call or message away — 24/7.
An independent Smeg Repair Service Center looking after fridges, ovens, dishwashers, washers and coffee machines right across the UAE.